Flintec DAD 141.1 Modbus Communication Instrukcja Użytkownika Pobierz pdf (Strona 5)

DAD 141.1 Technical Manual Modbus Communication, Rev. 2.3 - Juni 2014 Page 5

EEPROM

The 16 bit integer data is accessed by writing one 16-bit register at index 2066.The values are:

0001h: AS Save analog parameters

0002h: CS Save calibration

0004h: WP Save general setup parameters

0010h: SS Save set-point parameters

8000h: FD Factory default

2067

Int16

SetPoint

Selection

This Index is used to select Setpoint in a DAD141.

The 16 bit integer data is accessed by writing one 16-bit register at index 2067.

The values are 0 (zero) to 2 and selects the setpoint acted upon by indexes:

2068h,206Ah, 206Ch and 2070h.

This index act as the ‘n‘ parameter for the A’n‘, H’n‘, S’n‘ and P’n‘ commands

see also command description: A‘n‘ Assign action, H‘n‘ Hysteresis, S‘n‘ Setpoint, P‘n‘ Polarity

2068

Int32

SetPoint Source

This Index is used to select Setpoint Source in a DAD141.

The 32 bit integer data accessed by reading or writing 2 16-bit registers from index 2068.

0 = Gross weight as setpoint source

1 = Net weight as setpoint source

2 = Peak value (Max) as setpoint source

3 = Average value as setpoint source

4 = Hold value as setpoint source

5 = Peak to Peak value as setpoint source

6 = Valley value (Min.) as setpoint source

7 = Error 4 or 5 as setpoint source

see also command description: A’n‘ (n = 0, 1, 2, 3, 4, 5, 6, 7, 8)

206A

Int32

SetPoint

Hysteresis

This Index is used to get or set Setpoint Hysteresis in a DAD141.

The 32 bit integer data accessed by reading or writing 2 16-bit registers from index 206A.

see also command description: H’n‘ (n = 0, 1, 2)

206C

Int32

SetPoint Value

This Index is used to get or set Setpoint limit in a DAD141.

The 32 bit integer data accessed by reading or writing 2 16-bit registers from index 206C.

see also command description: S’n‘ (n = 0, 1, 2)

2070

Int32

SetPoint Polarity

This Index is used to get or set Setpoint polaritiy in a DAD141.

The 32 bit integer data accessed by reading or writing 2 16-bit registers from index 2070.

The values of switch logic are 0 or 1.

see also command description: P’n‘ (n = 0, 1, 2)

1 2 3 4 5 6 7 8 9 10

Komentarze do niniejszej Instrukcji

Brak uwag

Flintec DAD 141.1 Modbus Communication Instrukcja Użytkownika Strona 5

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Sprzęt komputerowy Flintec DAD 141.1 Modbus Communication